Pulsar Zenith 140 - Page 77

PULSAR MEASUREMENT
77
P212, 222, 232, 242, 252, 262 Relay Alarm ID
When P211, 221, 231, 241, 251, 261 = 8 (Device Alarm)
This parameter defines which digital input, the alarm should respond to, as
follows.
OPTION
DESCRIPTION
SETPOINTS
1 = Fail Input 1 (Default)
Relay goes “ON” when a device
fail signal is detected on digital
input 1.
None
2 = Fail Input 2
Relay goes “ON” when a device
fail signal is detected on digital
input 2.
None
3 = Fail Input 3
Relay goes “ON” when a device
fail signal is detected on digital
input 3.
None
4 = Fail Input 4
Relay goes “ON” when a device
fail signal is detected on digital
input 4.
None
5 = Fail Input 5
Relay goes “ON” when a device
fail signal is detected on digital
input 5.
None
6 = Fail Input 6
Relay goes “ON” when a device
fail signal is detected on digital
input 6.
None
7 = Fail Input 7
Relay goes “ON” when a device
fail signal is detected on digital
input 7.
None