Pulsar Zenith 140 - Page 76

ZENITH 140 INSTRUCTION MANUAL
76
P212, 222, 232, 242, 252, 262 Relay Alarm ID
When P211, 221, 231, 241, 251, 261 = 7 (Device Fail)
This parameter defines which failed device relay, the alarm should respond
to, as follows.
OPTION
DESCRIPTION
SETPOINTS
1 = Fail Relay 1 (Default)
Relay goes “ON” when a device
failure is detected on relay 1.
None
2 = Fail Relay 2
Relay goes “ON” when a device
failure is detected on relay 2.
None
3 = Fail Relay 3
Relay goes “ON” when a device
failure is detected on relay 3.
None
4 = Fail Relay 4
Relay goes “ON” when a device
failure is detected on relay 4.
None
5 = Fail Relay 5
Relay goes “ON” when a device
failure is detected on relay 5.
None
6 = Fail Relay 6
Relay goes “ON” when a device
failure is detected on relay 6.
None
7 = Any 1 Fail
Relay goes “ON” when a device
failure is detected on any 1
relay.
None
8 = Any 2 Fail
Relay goes “ON” when a device
failure is detected on any 2
relays.
None