To Next Page

To Previous Page

ENFORCER V11 PROGRAMMING GUIDE

CONTROL INPUTS?

Learn devices?

This menu starts the procedure of learning wireless zones onto the system.

Input

This menu chooses which zone on the system is to be learned. ‘Learnt’ will be displayed if a device is already

learnt, or ‘Available’ if it is not.

Learning…

Open the wireless device.

Remove the plastic insulation to enable the battery.

If the device is not learnt, the GREEN and RED LEDs on the device will ash (alternating).

Press and hold the ‘learn’ button on the device and all three LEDs start cycling BLUE, GREEN and RED.

Release the ‘learn’ button. If successful, ‘Input Learnt’ will be displayed on the keypad and a conrmation tone will

be emitted.

If that zone has already been learnt, ‘Input learnt already’ will be displayed.

To locate the learn button on each wireless peripheral, please refer to the installation guide provided with the

device.

Delete devices?

Already learnt zones may be deleted from this menu.

Delete all

To delete all wireless zone devices, enter ‘2000’. ‘Please wait’ will be displayed while the system deletes all the learnt

wireless zones.

Choose input to delete

This option deletes only a specic wireless device learnt to a zone. Any zones that display ‘learnt’ can be deleted.

‘Please wait’ will be displayed while the panel deletes the wireless device. Return to this process to delete more

devices.

Control bells?

Learn devices?

Entering this menu allows the learning of wireless bells onto the system.

Select bell

Selects the bell on the system that is to be learnt. ‘Learnt’ will be displayed if a bell is already learnt, or ‘Available’

will be displayed if not.

Learning…

Open the wireless bell.

Plug the battery connector into the battery terminal.

If a device is not learned, the GREEN and RED LEDs on the device will ash (alternating).

Press and hold the ‘Learn’ button on the device and all three LEDs start cycling BLUE, GREEN and RED.

Release the ‘Learn’ button. If successful, ‘Bell Learnt’ will be displayed and a conrmation tone on the panel will be

emitted.

If a siren has already been learnt, ‘Bell learnt already’ will be displayed.

Pyronix ENFORCER V11 Programming Guide

Other manuals for Pyronix ENFORCER V11