Pyronix ENFORCER V11 - Default Codes; Access Codes; Clean Start Codes; Other Codes

5
ENFORCER V11 PROGRAMMING GUIDE
DEFAULT CODES
ACCESS CODES
User Code
‘Blank’
Master Manager Code
2222
Engineer
1111
CLEAN START CODES
Clean start with the code ‘2000’ (UNGRADED)
Clean start with the code ‘2020’ (Grade 2)
Hint: For information on the system clean start defaults, see “Appendix A - Defaults” on page 44
OTHER CODES
Keypad Security Code
2000
Delete All Wireless Data
2000
ENGINEER MENU NAVIGATION
The Engineer Menu must be accessed in order to program all system congurations.
Please note
1. All tamper alarms (including case tamper), will be disabled once in the Engineer Menu.
2. All personal attack and re alarms will not cause an alarm in the Engineer Menu.
ACCESSING THE ENGINEER MENU
Access to the Engineer Menu will be allowed if the system is disarmed. If armed, the system must be disarmed rst
via a valid user code, tag or keyfob in order to gain access. If the ‘Allow Engineer Menu’ function in the Master
Manager Menu is set as ‘No’, the message ‘Authorisation Required’ will be shown and access will be denied until
this option is set as ‘Yes’.
1. Enter the Engineer code (default 1111).
2. If any faults that are active, they will be displayed now on the screen. Press h and enter the Engineer code
again.
3. ‘SET DATE & TIME?’ is displayed.
4. Engineer Menu has been accessed.
When the Engineer Menu is accessed, a high pitch tone is generated intermittently.
IMPORTANT NOTE: It is essential that a factory default (clean start) is performed after initial power up to
ensure that the correct defaults have been chosen.