Pyronix ENFORCER V11 Programming Guide

54
ENFORCER V11 PROGRAMMING GUIDE
APPENDIX D  OUTPUT TYPES
NO. TYPE ACTIVE RESTORE
0000 Not Used (Permanently o)
0001 Fire At alarm When a valid code is entered
0002 Hold Up Any "At a HU or Duress alarm
(This includes keypad HU)"
When a valid code is entered
0003 Intruder Any At alarm, while system is disarmed At rst valid code entry and at end
of conrm time.
0005 Misoperation Any
(Abort)
When system is silenced after any
‘intruder’ output is triggered
After 2 minutes
0006 Conrmed Any After two ‘intruder’ alarm activations At next code entry
0007 Tamper Any Any tamper alarm At code entry to silence And at end
of conrm time.
0008 Duress At a Duress alarm (i.e. from a
keypad)
When a valid code is entered
0009 HU Device Any At alarm on a HU input only When a valid code is entered
0010 Gas At alarm When a valid code is entered
0011 Set Fail Pre-set time after start of exit time, if
exit procedure is not complete
At code entry to rearm
0012 Entry Deviation When deviation from entry route
occurs, during entry time
At code entry to disarm
0013 Secure Intruder Any At alarm, after exit time started,
until disarmed
At rst valid code entry and at end
of conrm time.
0014 Siren Any When alarm live When alarm silenced or when siren
timer expires
0016 Strobe Any When alarm live When alarm silenced or when
strobe timer expires
0017 Omit Rearm Any Zone omitted if active (or in
alarm condition) at the end of
conrmation time.
When system disarmed
0018 Unconrmed Any Any intruder alarm At code entry to silence
0021 Exit Starts Any When exit time starts to set FIRST
area
At code entry to unset LAST area
0022 Final Set Any When FIRST area is set At code entry to disarm LAST area
0023 Strobe Set Fail Works similar to output 016, but also res if the set fail timer expires.
0025 Keyswitch disarmed This output turns on for 5 seconds when the system is disarmed via a
keyswitch input (pulsed or latched)
0026 Set with Omit Activates when inputs are omitted on arming
0028 Power Fault Active during low volts and battery faults*. Restores at code entry after
fault cleared.
0029 Conrmed Intruder Any When more than one intruder
alarm activates
At next code entry

Pyronix ENFORCER V11 Specifications

General

App Compatibility	ProControl+
Battery Backup	Yes
Wireless Detectors	Yes
Wireless Siren	Yes
Repeaters	Yes
Two-Way Wireless Technology	Yes
Operating Temperature	-10°C to +40°C
Storage Temperature	-20°C to +60°C
Communication Options	PSTN
Wireless Zones	64