Pyronix ENFORCER V11 - Page 39

39
ENFORCER V11 PROGRAMMING GUIDE
Example 1
The below sequence shows what happens when the attributes are programmed as ‘Starts at Keypads [0]’ and
‘Stops at Digi [3]’
When the event is
triggered, only the
keypads are audible.
15 seconds later, the
internal sounders
become active.
After 30 seconds from the
initial event, the external
bells trigger.
45 seconds after the
sequence began, the
panel will signal the
event.
Example 2
The below sequence shows what happens when the attribute are programmed as ‘Starts at Bells Only [2]’ and
‘Stops at Digi [3]’
When the event is
triggered, the keypads,
internal sounders and
external bells are all
audible simultaneously.
15 seconds after the
activation, the system
signals the event.
Please note: Any signalling will depend on programming in other menus regarding externals
communications. See Communications Guide for more information.