QCT QuantaMesh - ONIE OS Update Verification; Verifying IP Address in ONIE; Updating Vendor OS Code

58 Network Switch Installation Guide
Appendix
e. Use the “ipcong” command to verify if the IP address setting is correct.
4 In ONIE Linux shell, use the “install_url” command to update the vendor OS code.
Use one of the following commands:
“install_url tftp://192.168.2.153/ly3-onie-installer-1.5.3”
or
“install_url ftp://192.168.2.153/ly3-onie-installer-1.5.3”
or
“install_url http://192.168.2.153/ly3-onie-installer-1.5.3”
• install_url: the command string
• tftp/ftp/http: use: the server protocol type
• 192.168.2.153: the server IP address that stores the installer le
• ly3-onie-installer-1.5.3: the installer le