8 Network Switch Installation Guide
SAFETY & REGULATORY INFORMATION
Laser Peripherals or Devices
• To avoid risk of radiation exposure and/or personal injury:
√ Do not open the enclosure of any laser peripheral or device.
√ Laser peripherals or devices are not serviceable.
√ Return to the manufacturer for servicing.
√ Use certied Optical Fiber Transceiver Class 1 Laser Product.
CAUTION
Regulatory and Compliance Information
Electromagnetic Compatibility Notices
FCC Verication Statement (USA)1.5.1.1
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device may accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit other than the one to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modications not expressly approved by the grantee of this device could void
the user’s authority to operate the equipment. The customer is responsible for ensuring the
compliance of the modied product.
Only peripherals (computer input/output devices, terminals, printers, etc.) that comply with FCC
Class A or B limits may be attached to this computer product. Operation with noncompliant
peripherals is likely to result in interference to radio and TV reception.
All cables used to connect to peripherals must be shielded and grounded. Operation with cables,
connected to peripherals, that are not shielded and grounded may result in interference to radio
and TV reception.
Europe (CE Declaration of Conformity)1.5.1.2
This product has been tested in accordance to, and complies with the Low Voltage Directive
(73/23/EEC) and EMC Directive (89/336/EEC). The product has been marked with the CE Mark to
illustrate its compliance.
To Next Page
Loading...
General