Qualigen FastPack IP System - Safety Features; Electrical Safety and Labels

2 65000159 Rev. 008 (06/17)
Safety Features
Electrical
The FastPack
®
IP Analyzer must be connected to a properly grounded outlet.
Nemko Mark Label
The application of the Nemko mark denotes that the FastPack
®
IP System meets
all requirements for electrical safety and is approved for use in the field.
Other Symbols
All symbols discussed on this page can be found on the inside door plate of the FastPack
®
IP Analyzer.
Biomedical Label
This symbol indicates the area in the analyzer that may contain potentially
infectious human serum or blood products. Healthcare personnel should always
wear disposable gloves when handling blood products. Adhere to state and
federal infection control guidelines. All blood specimens should be handled at the
Biosafety Level 2 as recommended for any potentially infectious material in the
Centers for Disease Control/National Institutes of Health manual, “Biosafety in
Microbiological and Biomedical Laboratories,” 1988.
Attention Label
Attention: Important information that must be read is located both in the
Procedure Manual as well as in the directional inserts for all assays performed on
the FastPack
®
IP System.
CE Mark Label
This label signifies that the FastPack
®
IP System conforms with all applicable health, safety and environmental
protection standards of the European Union.
IVD Label
The FastPack
®
IP System is an In vitro diagnostic medical device.