Need help?Do you have a question about the Qualigen FastPack IP System and is the answer not in the manual?
General| Type | Immunoassay Analyzer |
|---|---|
| Sample Types | Serum, Plasma, Whole Blood |
| Detection Method | Chemiluminescence |
| User Interface | Touchscreen |
| Connectivity | USB, Ethernet |
| Power Requirements | 100-240V AC, 50/60 Hz |
| Test Types | Immunoassay |
| Assay Time | 12-15 minutes |
| Measurement Principle | Chemiluminescent immunoassay |
Instructions for unpacking, powering on, and basic configuration.
Connecting to power and initiating the analyzer startup sequence.
When to calibrate, what you need, and the core procedure steps.
When to control test, what you need, and the procedure steps.
Specific sample pretreatment for Vitamin D control tests.
Conditions, items needed, and initial prep for running patient samples.
Common error messages and their corresponding causes and solutions.
Addresses issues related to pipette function and sample injection port.
Steps to reset the analyzer's calibration data.
To Next Page