Qualigen FastPack IP System - Page 19

65000159 Rev. 008 (06/17) 9
FastPack
®
IP System Set Up
Action
Instrument
Information
Illustration
Connect the large end of
the Serial Printer Cable to
the rear of the external
printer with a screwdriver,
or tighten screws by hand.
Analyzer should be turned
on and in “Ready” position.
Connect the other end of
the Serial Printer Cable to
the analyzer at the port
labeled COM1.
Plug the Desktop Power
Supply into the back of the
External Printer.
Plug the AC Power Cord
into the Desktop Power
Supply.
Plug the AC Power Cord
into the wall socket.
External Printer operates
with input voltage of 100
240±10% VAC and 50/60
Hz.
Press the Printer’s ON
switch located on the left
side.