Scale Calibration Scale Calibration
CubiScan 125 Service Manual 16
4. If the weight and weight units displayed are correct for the test weight you are using, proceed
to the next step.
If not, change the weight units as follows:
Tap the displayed weight unit. It will turn green. Then tap
[+] or [-] to change the unit (e.g.,
from “lb” to “kg”). Tap the weight unit again to save the changes and return the display to
normal.
If not, change the weight as follows:
Tap the displayed weight. It will turn green. Then tap
[Prev] or [Next] to select your digit
position. Tap
[+] or [-] to increase or decrease the selected value.
5. Tap
[Next] to continue, and the following screen is displayed.
Figure 7
First Scale Calibration Screen
To Next Page
Loading...
