Need help?Do you have a question about the Quantronix CubiScan 110 and is the answer not in the manual?
General| Brand | Quantronix |
|---|---|
| Model | CubiScan 110 |
| Category | Measuring Instruments |
| Language | English |
Details the warranty coverage period and scope for new products.
Outlines the specific terms, obligations, and limitations of the warranty.
Lists actions or situations that will invalidate the product warranty.
Provides technical details including electrical, measuring, environmental, and physical attributes.
Instructions for safely removing the CubiScan 110 from its shipping container.
Guide for attaching the back panel and connecting sensor cables.
Steps to properly adjust internal shipping bolts for accurate scale function.
Instructions for positioning and leveling the CubiScan for optimal performance.
Details on establishing communication via serial or Ethernet ports.
Steps to safely connect the CubiScan 110 to a power source.
Procedure for powering on the device and initiating self-calibration.
Guidance on installing the optional Qbit PC control software.
A checklist to verify all setup steps have been completed correctly.
Preliminary steps and notes before operating the CubiScan 110.
Instructions for performing measurements using the Qbit software interface.
Steps for measuring packages directly via the device's control panel.
How to measure packages that are not perfectly cuboidal.
Preparations required before starting the calibration process.
Detailed steps for sensor and scale calibration via the control panel.
Steps to access and configure the device for calibration mode.
Procedure for calibrating the device's dimensional sensors.
Procedure for calibrating the weight measurement capabilities of the scale.
Steps to return the CubiScan to normal operation after calibration.
Important safety and handling guidelines to prevent damage.
Instructions on how to properly clean the device's sensors.
Procedures for safely removing the controller box for service or inspection.
Steps to diagnose and resolve power-on issues.
Guidance on how to address inaccurate weight or dimension measurements.
Explains common error messages from the Qbit software and their causes.
Lists and explains error codes displayed on the CubiScan control panel.
Specific troubleshooting for communication timeouts between sensors and the controller.
Troubleshooting dimension measurement errors related to sensor communication.
Troubleshooting errors related to weight measurement and load cell communication.
Lists various other error codes and advises contacting support.
Describes the pinout for the RS-232 serial communication cable.
Details the pinout for the Ethernet RJ-45 connector.
Explains the commands used for controlling the CubiScan via serial or Ethernet.
Command to enable or disable continuous measurement mode.
Command set for performing scale calibration procedures.
Command set for calibrating the dimensional sensors.
Command to set measurement units to English or metric.
Command to switch between domestic and international dimensional factors.
Command to set the CubiScan's identification code.
Command to initiate package measurement and data transmission.
Command to set weight units to pounds or kilograms.
Command to perform internal compensations for temperature/humidity.
Commands for configuring TCP/IP network communication.
Command to set the CubiScan's TCP port number.
Command to read the current TCP port number setting.
Command to set the CubiScan's IP address.
Command to read the current IP address setting.
Command to set the CubiScan's subnet mask.
Command to read the current subnet mask setting.
Command to set the network gateway address.
Command to read the current gateway address setting.
Command to set the Ethernet inactivity timeout period.
Command to read the current inactivity timeout setting.
To Next Page
