Setup Setting Up the Back Panel
CubiScan 110 9
2. Using the same wrench, loosen, but do not remove, the socket
head cap screws on the hinges (one on each side of the scale
platter) as shown in Figure 5.
3. Rotate the back panel into its upright position, taking care not to
constrict the three sensor cables protruding from the back of the
scale platter.
4. Reinsert the four cap screws that you removed in step 1 through
the holes in the back panel into the holes in the back of the scale
platter, and tighten the screws.
5. Tighten the two hinge socket head cap screws that you loosened
in step 2.
Figure 5
Loosening the Hinge Cap Screws
To Next Page
Loading...
