Quantronix CubiScan 110 User Manual

Calibration Calibrating Using the Control Panel
CubiScan 110 33
8. Press <msr>. The WIDTH window displays 12.0.
9. Turn the calibration block so that it is pointing toward the front
with the end against the back panel, and place it in the center of
the platform, as shown below.
Figure 14
Calibration Block Placement for Left Length Sensor

Quantronix CubiScan 110 Specifications

General

Brand	Quantronix
Model	CubiScan 110
Category	Measuring Instruments
Language	English