Name: Quantronix CubiScan 110
Brand: Quantronix
Rating: 4 (1 reviews)

To Next Page

To Previous Page

CubiScan 110 5

Chapter 2

Setup

This chapter provides instructions for setting up the CubiScan 110.

Please read these instructions completely before attempting to set up

the CubiScan. Perform the steps to set up the CubiScan in the fol-

lowing order:

• Unpack the CubiScan (page 5)

• Set up the back panel (page 8)

• Adjust the shipping bolts (page 11)

• Place the CubiScan where you will be using it and level the

CubiScan (page 13)

• Connect the CubiScan to a computer or network (page 14)

• Connect power to the CubiScan (page 17)

• Install the Qbit PC control software (optional) (page 18)

• Calibrate the CubiScan (Chapter 4 “Calibration” on page 27)

Unpacking

To unpack the CubiScan, take the following steps.

1. Remove the top of the crate.

Questions and Answers:

Need help?

Do you have a question about the Quantronix CubiScan 110 and is the answer not in the manual?

Quantronix CubiScan 110 Specifications

General