Setup Placement and Leveling
CubiScan 110 13
Placement and Leveling
Place the CubiScan on a flat, hard surface. Be sure that nothing
touches the back wall or top platter of the CubiScan, as this may
cause weighing errors.
Take the following steps to level the CubiScan.
1. Place the bubble level provided in the center of the scale platter.
2. Adjust the five leveling feet under the CubiScan to level the
scale. Make sure all feet are touching the supporting surface.
NOTE
The CubiScan does not have to be perfectly level to weigh accu-
rately.
Figure 9
Bubble Level
☞
To Next Page
Loading...
Need help?
General
