Quantronix CubiScan 110 User Manual

TCP/IP Communications Setup Command Set Communications Protocol
76 CubiScan 110
Set Gateway Address
This command is used to set the network gateway address on the
CubiScan 110. It can be the address of a network server or router
and is expressed in “dot” notation. Consult your network adminis-
trator to obtain the network gateway address.
5
7-15
or n
Subnet Address Alpha
(0.0.0.0) to
(255.255.255.255)
5+n 1 End of Text Control (ETX) 03h
6+n 1 Carriage Return Control (CR) 0Dh
7+n 1 Line Feed Control (LF) 0Ah
Negative Acknowledge Format
1 1 Start of Text Control (STX) 02h
2 1 Read Command Alpha (~) 7Eh
3 1 Subnet Address Command Alpha (N) 4Eh
4 1 Neg. Acknowledge Alpha (N) 4Eh
5 1 End of Text Control (ETX) 03h
6 1 Carriage Return Control (CR) 0Dh
7 1 Line Feed Control (LF) 0Ah
Pos Len Description Type Range ASCII
Pos Len Description Type Range ASCII
Command Format
1 1 Start of Text Control (STX) 02h
2 1 Set Command Alpha (@) 40h
3 1 Gateway Address Command Alpha (G) 47h
4
7-15
or n
Gateway Address Alpha
(0.0.0.0) to
(255.255.255.255)
4+n 1 End of Text Control (ETX) 03h
5+n 1 Carriage Return Control (CR) 0Dh

Quantronix CubiScan 110 Specifications

General

Brand	Quantronix
Model	CubiScan 110
Category	Measuring Instruments
Language	English