Control Panel Error Messages Troubleshooting
46 CubiScan 110
Control Panel Error Messages
Several predefined error codes are programmed into the CubiScan
110 and, if a computer is not connected, may be displayed to iden-
tify specific errors. All errors are identified by a 2-digit code, which
is displayed on the control panel in the display window appropriate
for the message.
Error codes may appear occasionally during operation. This does
not necessarily indicate a problem with the CubiScan. The first time
an error code occurs, ignore it and redo the measurement. If the
error code is displayed again immediately or frequently, review the
sections below for information on specific codes.
NOTE
If an error message appears during calibration, power the Cubi-
Scan off and back on and start calibration over.
Timeout Error 01
If error code 01 is displayed in any window on the control panel, it
may imply a problem that can be easily corrected. If, after following
the suggestions below, the error code continues to be displayed,
contact Quantronix for assistance.
Length, Width,
Height
If timeout error 01 appears in the LENGTH, WIDTH, or HEIGHT
window, it indicates that no communication is taking place between
the sensor and the controller. The error code will appear in the dis-
play window (length, width, height) of the sensor that is at fault.
Consider the following.
1. Verify that the sensor connector has not been disconnected.
2. Inspect the sensor cable for damage. Replace the sensor cable if
it is damaged.
☞
To Next Page
Loading...
Need help?
General
