Installing Qbit (Optional) Setup
18 CubiScan 110
3. Allow the CubiScan to completely boot. After the boot process,
the scale reading on the control panel should be
0.0 and the
dimensions should be blank. The
zero indicator should be lit. If
not, press the
<zero> button on the control panel display to zero
the scale and sensors (refer to “zero” on page 24).
4. Place a box or calibration block on the CubiScan in the center
against the back panel, and press
msr on the control panel.
5. Verify that the weight and dimension readings are correct.
6. Remove the box or calibration block from the platform.
The CubiScan is now ready for use.
Installing Qbit (Optional)
A CD-ROM is provided containing the applicable version(s) of the
Qbit software program, which can be used to operate the CubiScan
110.
QbitTCP is a Qbit application for configuring the Cubiscan 110
(through the RS-232-C port) for TCP/IP communication.
The Qbit User Guide, located on the CD-ROM, provides instruc-
tions for installing and using Qbit. You can also download the user
guide from the Quantronix Web site at www.cubiscan.com.
To Next Page
Loading...
