Communications Protocol TCP/IP Communications Setup Command Set
CubiScan 110 71
Set IP Address
This command is used to set the CubiScan 110 IP address. The IP
address, or Internet address, is usually expressed in “dot” notation;
for example, “121.43.6.234.” The first three groups of numbers
(e.g., 121.43.6) are usually specific to the network to which you are
2 1 Read Command Alpha (~) 7Eh
3 1 Port Command Alpha (P) 50h
4 1 End of Text Control (ETX) 03h
5 1 Carriage Return Control (CR) 0Dh
6 1 Line Feed Control (LF) 0Ah
Acknowledge Format
1 1 Start of Text Control (STX) 02h
2 1 Read Command Alpha (~) 7Eh
3 1 Port Command Alpha (P) 50h
4 1 Acknowledge Alpha (A) 41h
5 1-5 or n Port Alpha (1) to (65535)
5+n 1 End of Text Control (ETX) 03h
6+n 1 Carriage Return Control (CR) 0Dh
7+n 1 Line Feed Control (LF) 0Ah
Negative Acknowledge Format
1 1 Start of Text Control (STX) 02h
2 1 Read Command Alpha (~) 7Eh
3 1 Port Command Alpha (P) 50h
4 1 Neg. Acknowledge Alpha (N) 4Eh
5 1 End of Text Control (ETX) 03h
6 1 Carriage Return Control (CR) 0Dh
7 1 Line Feed Control (LF) 0Ah
Pos Len Description Type Range ASCII
To Next Page
Loading...
