Connecting to a Computer or Network Setup
16 CubiScan 110
3. Insert the RJ-45 connector on the other end of the cable into the
network socket and push until it latches.
For information on the Ethernet cable pin-outs, refer to “Ether-
net (TCP/IP) Cable Pin Assignments” on page 50.
4. Use Quantronix’ QbitTCP software to configure the Cubiscan
110 (through the RS-232-C port) for TCP/IP communication, or
refer to Appendix A “Communications Protocol” on page 49 for
information on the TCP/IP command protocol and setup param-
eters. Contact Quantronix if you need additional assistance.
When it is turned on, the CubiScan 110 will recognize the cable
connection and, if configured correctly, will respond to a connection
request from the host.
NOTE
You can also connect the CubiScan 110 directly to a computer
through a 10-BaseT Ethernet TCP/IP port via a standard Ethernet
cable. A crossover cable is required.
Figure 10
Ethernet Cable Connector
☞
To Next Page
Loading...
