Quantronix CubiScan 125 - Page 78

Communication Protocol CubiScan 125 Command Set
CubiScan 125 Service Manual 68
* This field may contain underscores, dashes, or tildes indicating an under, unstable, or over
error condition, respectively. Leading spaces (20h) will be used when the actual data does not fill
the entire field.
Gate Measure
The CubiScan 125 will automatically send measurement data upon completion of a gate
measurement.
51 1 Wgt./Dim.Wgt Unit Alpha (E/M) 45h or 4Dh
52 1 Comma Alpha (,) 2Ch
53 1 Factor Identifier Alpha (F) 46h
54 4 Factor Numeric 0000-9999
58 1 Comma Alpha (,) 2Ch
59 1 Domestic/Int'l. Unit Alpha (D/I) 44h or 49h
60 1 End of Text Control (ETX) 03h
61 1 Carriage Return Control (CR) 0Dh
62 1 Line Feed Control (LF) 0Ah
Negative Acknowledge Format
1 1 Start of Text Control (STX) 02h
2 1 Measure Command Alpha (M) 4Dh
31Neg. Acknowledge Alpha (N) 4Eh
41
CubiScan/Host
Originated
Alpha (C/H) 43h or 48h
51
Corner Sensor / Measure
/ Zero Error
Alpha (C/M/Z) 43h or 4Dh
61End of Text Control(ETX) 03h
7 1 Carriage Return Control (CR) 0Dh
81Line Feed Control(LF) 0Ah
Pos Len Description Type Range ASCII
Acknowledge Format
1 1 Start of Text Control (STX) 02h
2 1 Measure Command Alpha (m) 6Dh
3 1 Acknowledge Alpha (A) 41h
41
CubiScan/Host
Originated
Alpha (C/H) 43h or 48h
56City Code Alpha
000000-ZZZZZ
Z
Pos Len Description Type Range ASCII