© Copyright Qvis ®. All documentation rights reserved.
Figure 7-61
Please refer to the following sheet for detailed information:
Here you can select date format from the dropdown list.
There are two options: 24-H and 12-H.
The time zone of the device.
This is to set system time. It becomes valid after you set.
You can click this button to save the system time as your PC current
time.
Here you can set day night save time begin time and end time. You
can set according to the date format or according to the week
format.
You can check the box to enable NTP function.
You can set the time server address.
This is to set the time server port.
This is to set the sync periods between the device and the time
server.
7.8.5.1.3 Holiday Setup
Holiday setup interface is shown as in Figure 7-62.
Here you can check the box here to enable this function and then set.
To Next Page
Loading...
Need help?
General
