RadioLink Crossflight User Manual

Radiolink Electronic Ltd
www.radiolink.com
6
Operating Parameters
USB Voltage
5V±0.3V
Servo Voltage
Not applicable
Operating Temperature
-40~80℃
1.3 Advices
For the users who firstly use CrossFlight, we suggest that you use CrossFlight following below steps:
1. You have to install the mission planner and driver from here and familiar with the menu.
Download the latest Mission Planner from here: https://www.radiolink.com/CrossFlight_missionplanner
Download the driver form here: https://www.microsoft.com/net/download/dotnet-framework-runtime/net462
2. To establish a connection, you must first choose the communication method/channel you want to use, and
then set up the physical hardware and Windows device drivers. You can connect the PC and autopilot using
USB cables, Telemetry Radios, Bluetooth, IP connections etc.
3. Download the update firmware by USB cable if you need.
4. Connect Mission Planner to AutoPilot, and then connect receiver to AutoPilot to finish the calibration of
transmitter, Accelerometer and compass.
5. Setup RC transmitter flight mode.
6. Assemble aircraft and finish the pre-flight checklist.
7. PID usage.
8. Advanced configuration.
2. Mission Planner
2.1 Install Mission Planner
Net Framework 4.6.2 need to be installed first before Mission Planner;
Download Net Framework 4.6.2 here
Then you can download Mission Planner for CrossFlight on RadioLink official website:
https://www.radiolink.com/CrossFlight_missionplanner

RadioLink Crossflight Specifications

General

Brand	RadioLink
Model	Crossflight
Category	Controller
Language	English