RadioMaster MT12

T-Source: The source that will be used for the throle.
T-Trim-Idle: When enabled, the throle trim will only aect the boom poron of the throle band.
For example, with Trim idle only enabled, the throle sck at the lowest point might have a value of -80 and the
center point will sll be 0 and the highest point of 100. Without this enabled, the throle sck at the lowest point
might have a value of -80 however, the center point will be 20 and the highest point of 100.
T-Trim-SW: The trim switch that will be used to trim the throle. It is possible to substute the throle trim switch
with the aileron, rudder, or elevator trim switches.
Preight Checks opons
Preight Checks
Whenever a new model is loaded, EdgeTX will conduct pre-ight checks based on the checks that are congured on
this page. If any of the checks are failed, EdgeTX will give the user an audio and visual warning that must be
acknowledged before using the model. The following preight checks below are displayed in collapsible menu.
Checklist - When this opon is selected, the model notes le will be displayed when the model is loaded. A valid
model notes le must be in the Models folder on the SD card. The model notes le must be a .txt le and must have
the EXACT same name as the model it is for, for example: Mobula6.txt. The text in the le is up to the user.
T-Warning - When selected, the radio will check that the throle is at the minimum value for the congured throle
source in the T-Source conguraon opon.
Cust-Pos - When this opon is selected, the value designated in POS.% will be used for the T.Warning.
Pos.% - minimum value of the throle for the throle warning when Cust-Pos is enabled.
S-Warning - The secon displays all the switches that are congured on the radio and allows you to select which
posion is the correct posion for the switch state check. Selecng the switch will cycle through the available switch
posions or turn the check o for the switch completely.
Pot warn- When acvated, this opon checks the posion of the pots & sliders. There are three opons - OFF, ON
and AUTO. When ON or AUTO is selected, buons for the available pots and sliders will appear. To enable the Pot
warning for an individual Pot, select the pot with the [roller] or [dial] and click the buon to highlight it. Highlighted
pots are enabled.
• OFF - Pot and slider posions are not checked.
• Manual - Posions are checked against manually congured pot and slider posions. To manually set the
check posion, select manual the from menu, select the item that you want to set, and long-press the
[Enter] buon to set its current posion for the check.
• AUTO - Posions are checked for pots and sliders and compared to the last automacally saved posion
before the radio was turned o or the model was changed.
Ctr Beep - Allows you to turn on/o the centre beep funcon for the individual scks, pots, and sliders by
highlighng them with the [roller] or [dial] and pressing the buon. When a switch is highlighted, the funcon is
enabled.