RadioMaster MT12

However, this automacally assigned value can be manual changed. Note: In most cases, the default
seng does not need to be changed.
• Master / Bluetooth - Master mode using a Bluetooth connecon (if installed in radio).
• Slave / Bluetooth - Slave mode using a Bluetooth connecon (if installed in radio).
• Master / Mul - Master mode using an addional externally mounted Mul-protocol module for the
connecon. For more informaon on this setup, see Set-up wireless trainer with a Mul -protocol module
Enabled Features opons
Enabled Features
The Enabled Features secon allows you to congure which pages are visible in the selected model's radio setup and
model sengs area of EdgeTX. The page names are displayed in a collapsible menu with the following congurable
opons:
• Global - When selected, the tab will take the global value congured in the Enabled Features area in Radio
Setup. The congured global value will display next to the opon.
• On - When selected, this tab will be visible when this model is loaded.
• O - When selected, this tab will not be visible when this model is loaded.
Note: Turning o a tab only hides the tab and does not change the items already congured in that tab. For example,
if you congure a special funcon and then turn o the special funcons tab, the special funcon will sll work as
congured.
EXCEPTION: Turning o the Global Funcons tab will disable congured global funcons for that model.
USB Joysck advanced mode sengs
USB Joysck
The USB Joysck has two possible modes, Classic and Advanced.
In Classic mode, the radio's congured output channels will be sent to the target device in numerical order and
mapped to the device's precongured USB controller axes and buons. Below is the default channel mapping for
Microso Windows.
• Ch1 - X Axis
• Ch 2 - Y Axis