10
IQ Network Communication Cartridge
Install an External Antenna for LXMM
If the LXMM Metal Case is used along with the a NCC-GP
or NCC-WF cartridge, then an external antenna must be
installed in place of the internal antenna provided. These
external antennas are not included with the NCC and must
be purchased separately.
A
Using a power drill and 5/8” (16 mm) drill bit, drill
a hole through the “dimple” on the top right of the
LXMM metal case.
d
CAUTION: always wear eye protection when using
tools or power equipment.
1
B
Using a screwdriver or other pointed tool, center
the point of tool on the “dimple” in the center of the
knock-out, punch through and remove the antenna
knock-out hole located on the top right of the ESP-LX
controller plastic case.
2
To Next Page
