38
IQ Network Communication Cartridge
Connection Module Installation
Follow these steps if a connection module is required for
IQNet wired communications:
A
To remove an existing base module, press in on the
two release buttons on each end of the module to
release it from slot 0.
b
NOTE: The ESP-LXD does not ship with a base module.
Remove the black plastic cover on the backplane in
slot 0 to reveal the pins on the connector.
1
B
Orient the connector on the bottom of the IQ-FSCM-
LXME or IQ-CM-LXD module with the connection
socket on the satellite backplane.
C
Carefully fasten the module onto the satellite
backplane, pressing rmly until it snaps into place.
2
To Next Page
