Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
827User Manual 1178.8520.02 ─ 01
[SENSe:]LIST:RANGe<ri>:DELete................................................................................... 828
[SENSe:]LIST:RANGe<ri>:DETector.................................................................................828
[SENSe:]LIST:RANGe<ri>:FILTer:TYPE............................................................................829
[SENSe:]LIST:RANGe<ri>:INPut:ATTenuation...................................................................829
[SENSe:]LIST:RANGe<ri>:INPut:ATTenuation:AUTO.........................................................829
[SENSe:]LIST:RANGe<ri>:INPut:GAIN:STATe...................................................................830
[SENSe:]LIST:RANGe<ri>:INPut:GAIN[:VALue].................................................................830
[SENSe:]LIST:RANGe<ri>:LIMit:STARt.............................................................................830
[SENSe:]LIST:RANGe<ri>:LIMit:STATe.............................................................................830
[SENSe:]LIST:RANGe<ri>:LIMit:STOP............................................................................. 831
[SENSe:]LIST:RANGe<ri>:POINts[:VALue]....................................................................... 831
[SENSe:]LIST:RANGe<ri>:RLEVel................................................................................... 831
[SENSe:]LIST:RANGe<ri>:SWEep:TIME.......................................................................... 831
[SENSe:]LIST:RANGe<ri>:SWEep:TIME:AUTO................................................................ 832
[SENSe:]LIST:RANGe<ri>:TRANsducer........................................................................... 832
[SENSe:]LIST:RANGe<ri>:BANDwidth:RESolution <RBW>
This command defines the resolution bandwidth for a spurious emission measurement
range.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<RBW> Resolution bandwidth.
Refer to the data sheet for available resolution bandwidths.
Default unit: Hz
Manual operation: See " RBW " on page 257
[SENSe:]LIST:RANGe<ri>:BANDwidth:VIDeo <VBW>
This command defines the video bandwidth for a spurious emission measurement
range.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<VBW> Video bandwidth.
Refer to the data sheet for available video bandwidths.
Default unit: Hz
Manual operation: See " VBW " on page 257
[SENSe:]LIST:RANGe<ri>:BREak <State>
This command controls the sweep (for all ranges, <range> is irrelevant).
Configuring and Performing Measurements
To Next Page
Loading...
Need help?
General
