Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
893User Manual 1178.8520.02 ─ 01
Parameters:
<Ratio> Range: 0.0001 to 1
*RST: 0.01
Example:
BAND:RAT 0.1
Manual operation: See " Span/RBW " on page 385
[SENSe:]BWIDth[:RESolution]:TYPE <FilterType>
[SENSe:]BANDwidth[:RESolution]:TYPE <FilterType>
This command selects the resolution filter type.
When you change the filter type, the command selects the next larger filter bandwidth if
the same bandwidth is unavailable for that filter.
Example:
BAND:TYPE NORM
Manual operation: See " Filter Type " on page 385
[SENSe:]BWIDth:VIDeo <Bandwidth>
[SENSe:]BANDwidth:VIDeo <Bandwidth>
This command defines the video bandwidth.
The command decouples the video bandwidth from the resolution bandwidths.
Parameters:
<Bandwidth> refer to data sheet
*RST: AUTO is set to ON
Default unit: HZ
Example:
BAND:VID 10 kHz
Manual operation: See " VBW " on page 384
[SENSe:]BWIDth:VIDeo:AUTO <State>
[SENSe:]BANDwidth:VIDeo:AUTO <State>
This command couples and decouples the video bandwidth to the resolution band-
width.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
BAND:VID:AUTO OFF
Manual operation: See " VBW " on page 384
See " RBW/VBW " on page 385
See " Default Coupling " on page 386
Setting Basic Measurement Parameters
To Next Page
Loading...
Need help?
General
