R&S SMW200A - Page 67

Trying Out the Instrument
R&S
®
SMW200A
67Getting Started 1412.9220.02 ─ 21
This example shows you how to use this graphical display to verify the generated
signal. Use the signal generated in Chapter 6.5, "Routing the Signal through the
Instrument and Defining the Output Connectors", on page 61.
To access the graphical signal display functionality
► Perform one of the following:
a) Select "Taskbar > System Configuration > Graphics"
b) On the "Taskbar", tap the wave icon.
The "Graphics Configuration" dialog opens.
To visualize the sum signal
1. In the "Graphics Configuration" dialog, select "Mode > Power Spectrum".
2. Select "Source > A Stream".
3. Select "Add" to enable signal display.
Verifying the Generated Signal with the Graphics Display