R&S ZVA8 - Replacing Generator and Receiver Cover (ZVA8 Only)

Repairs R&S ZVA
1177.5333.02 3.60 E-11
Replacing Generator and Receiver Cover (ZVA8 only)
(See Service Circular 10028 and Chapter 5, Spare Parts List, Items 130, 150 and drawing
1302.4960.08)
Opening the instrument and removing the cover
 Remove the reflectometer (see chapter Replacing Reflectometer Board A510 to A540)
 Remove the RM mount (200), 4 screws (210)
 Remove the covers (130, 150)
Installing the cover and reassembling the instrument
 Fit the new covers (130, 150)
 Refit the RM mount (200)
 Reinstall the reflectometer (see chapter Replacing Reflectometer Board A510 to A540)
 Connect the mains cable, turn on at the mains switch and press the ON key.
 Select Service Level 2 (see Service Functions).
 When the instrument has been started, check the protocol file for errors:
[ INFO : Error Log ]
 Record the receiver correction data (see Recording Correction Values in chapter 2).
 Perform the factory system error calibration (see Factory System Error Calibration in chapter 2).