R&S ZVA8 - Checking the Receiver Attenuator (Only with Option Receiver Attenuator)

Performance Test R&S ZVA
1177.5333.02 1.14 E-11
Checking the Receiver Attenuator (only with Option Receiver Attenuator)
Test equipment:
Calibration kit N
(see Chapter “Test Equipment“, Item4)
Test setup:
Connect Short Male to port#
R&S
®
ZVA settings:
- [ Preset ]
- [ Meas : Wave Quantities : b#/ Src Port #]
- [ Power : 0 dBm ]
- [ Meas Bandwidth : 100 Hz ]
- [Trace Funct : Data -> Mem : Math = Data/Mem : Show Mem off]
- [Pwr BW AVG : Receiver Step Atten : Port # {a Rec Att}*]
- [Trace Funct : Shift Response Value : Magnitude { -a Rec Att}]
- [Marker]
* For attenuator settings {a Rec Att}, see Performance Test Report.
Measurement:
Read off the network analyzer’s marker values (for marker frequencies
see Performance Test Report)