Rapid Shape Operating Instructions
Caution
Non-observance of the precautionary measures can lead to material damage of the
equipment as well as the environment.
Caution
Loading and unloading, as well as positioning/setting up the machine, may only be
performed by qualified personnel. Always lift and transport the machine in twos. When
using lifting devices, the lifting device’s weight must comply with the weight of the machine
(see technical details – chapter 3). The requirements of the machine’s installation site must
be observed.
4.1 General instructions
The machine may only be transported in the packaging supplied and with sufficient protection against tilting
over.
Store the transport packaging for future use (change of location, maintenance, repair etc.). Returns without
original transport packaging cannot be accepted.
4.2 Transport damage
After receipt of the delivery carefully check the transport packaging as well as the product supplied for any
damage that could have occurred during transport. Transport damage is to be reported to the forwarding
agent and Rapid Shape immediately.
5 Preparations
5.1 Requirements for the installation site
In order to ensure a smooth and trouble-free operation of the 3D printer system, please observe the
following stipulations for the machine’s installation site:
- Set up in a room separated from other permanent work
- Set up only in a dust-free area
Beware of milling dust
- A sufficient supply of fresh air is to be assured in the room
In this respect, also always observe the stipulations of the respective material manufacturers (safety data sheet)
- The machine as well as the materials are to be protected from exposure to direct sunlight
- The room is to be equipped with UV-protected lighting
- Windows are to be UV protected / shaded or fitted with UV protective film
- A strong foundation for setting up the machine
- Room requires LAN network and internet connection for service purposes
- Optional: Room with fresh water supply and sink unit
To Next Page
Loading...
