Rapid Shape P20+ - 10 Final decommissioning; 10.1 Shutting down the machine

Service
Rapid Shape Operating Instructions
DOCR000225
Page 36 / 37
9 Service
Our service team would gladly offer any help you need regarding all queries or problems.
If you have
- questions on rectifying faults on Rapid Shape machines
- general questions concerning Rapid Shape machines
- general queries concerning materials sold by Rapid Shape
- general questions concerning netfabb
- specific questions on material specifications in netfabb
- any other queries concerning Rapid Shape machines
please call our Service Team:
Company name:
Rapid Shape GmbH
Address:
Römerstraße 21
Town:
71296 Heimsheim
Phone:
+49 (0) 7033 309878-0
Fax:
+49 (0) 7033 309878-40
Internet:
http://www.rapidshape.de
Mail:
service@rapidshape.de
10 Final decommissioning
10.1 Shutting down the machine
(1) In main menu, select “Shut Down”. The shutdown dialog appears. After 10 minutes, the machine will
be switched off automatically.
(2) Select “Shutdown” in order to shut down the machine earlier.
Only switch off the main switch after the machine has been completely shut down!
10.2 Storage
Store the machine on a dry and level surface which is protected against moisture.
11 Disposal
• It is recommended to wear suitable protective cloths. (protective gloves, if
necessary, other protective cloths)
• Disassembly work may only be performed by qualified personnel.
Incorrect disposal of electronic waste, electric components, lubricants and other
additives can be hazardous to the environment. Therefore, dispose machine
components as intended by your waste disposal company or by authorized specialist