Rapid Shape Operating Instructions
5.4 IT requirements
A computer is required to generate the print data for the machine. The following points are to be observed in
this respect.
5.4.1 PC hardware
In order to use the slicing software from netfabb, you require a computer that fulfils the following
requirements:
- Computer for CAD design, nesting and slicing
Quad core CPU (Intel Core i5 or i7) @ 2.50 GHz
At least 4GB main memory (8GB recommended)
1GB+ free hard disc memory
Windows 7 32-bit/64-bit or higher
LAN connection
Internet connection
- Network connection between computer and machine
(e.g. via router)
5.4.2 PC software
The following software must be installed on the computer intended for use.
- Operating system Windows 7 32-bit / 64-bit (optional) or higher
- TeamViewer Host (as from version 10)
- netfabb Rapid Shape Version (delivered on the USB stick)
For more information on the software used:
- http://www.microsoft.com
Here you can obtain information on the operating system used
- http://www.teamviewer.com
Here you can obtain information on trouble-shooting or the latest updates for TeamViewer.
- http://www.microsoft.com
Here you can obtain all information required for the slicing software netfabb.
5.4.3 IP address
The default setting for the system is DHCP (dynamic IP address).
Should a static IP address be used, this can be set in the menu under "Settings"
(see Chapter 7.10).
Should you require details of your IP address please contact your administrator.
5.4.4 Internet access / TeamViewer port
- The computer to be used for netfabb requires internet access in order to obtain
regular software updates and material libraries
- Moreover, this computer requires approval to use the TeamViewer program so
that, if required, the service team can access the computer.
To Next Page
Loading...
Need help?
General
