Rapid Shape Operating Instructions
dimensional support files (*_s.stl)
— Offset: changes the size of the
component towards X- and Y-
direction by the set absolute value
— Shrinkage: changes the size of the
component towards X- and Y-
direction by the set percentage value
— Z-Compensation: changes the size of
the component by the set absolute
value
Process properties:
— Burn in factor: prolongs/shortens the
burning in time of the first layers
— Separation Force: decreases/
increases the separation force when
loosening the building platform from
the material reservoir after having
burned in the layers
Note: It’s possible that not all displayed parameters
are available.
(6) Save your changes by clicking on the
button “OK”.
In case of a corresponding maintenance contract, the material parameters will be updated
on a regular basis. In case of an update of already existing materials, the existing parameter
set will be left unchanged.
To Next Page
Loading...
