Layout and function
11
2
The icons and displays in the example have the following meaning:
No. Icon/display Meaning (in the example shown)
1 Metering slide
scale opening left
Current opening position of the left metering slide.
2 Operating mode Shows the current operating mode.
3 TELIMAT icon This icon appears on the right for AXIS and on the left
for MDS if the TELIMAT sensors are installed and
the TELIMAT function is enabled (factory setting) or
the T button is activated.
4 Quantity change
right
Quantity change (+/-) in percent.
Display of quantity changes.
Range of values +/- 1...99% possible.
5 Application rate Preset application rate.
6 Display fields Individually configurable display fields (here: forward
speed, flow factor, residual kg).
Possible configuration: see chapter
4.10.2: Display configuration, page 72
.
7 Icon fields Icon assignment to the fields depending on the
menu.
Selection of the function by means of the func-
tion keys below.
8PTO speed EMC function only: Current PTO speed
See 4.6.8: PTO shaft, page 49
9 Drop point Current position of the drop point.
10 Section left Display of status of left section. See 2.4.2: Display of
the metering slide status, page 12.
11 Left application
rate adjustment
Quantity change (+/-) in percent.
Display of quantity changes.
Range of values +/- 1...99% possible.
To Next Page
Loading...