Operation QUANTRON-A
49
4
4.6.7 Spreading disc type
The mounted spreading disc type is preset in the control unit at the factory. If you
have mounted different spreading discs on your machine, you must enter the cor-
rect type in your control unit.
1. Open the Fertiliser settings > spreading disc menu item.
2. Highlight the disc type with the bar in the selection list.
3. Press the Enter key.
The selected disc type is marked with a tick.
4. Press the ESC key
The Fertiliser settings window with the new spreading disc type is dis-
played.
4.6.8 PTO shaft
The specified PTO speed is preset in the control unit to 540 rpm as a standard
factory setting. If you want to set a different PTO speed, you must change the
stored value in the control unit.
1. Open the Fertiliser settings > PTO menu item.
2. Enter the RPM.
See chapter 4.13.2: Entering values with the cursor keys, page 84
.
3. Press the Enter key.
The display shows the Fertiliser settings window with the new PTO
speed.
NOTICE
For optimal idle measurement check the correct entries are in the Fertiliser
settings menu.
The entries in the Spreading disc and PTO shaft menu items must comply
with the actual settings of your machine.
NOTICE
For optimal idle measurement check the correct entries are in the Fertiliser
settings menu.
The entries in the Spreading disc and PTO shaft menu items must comply
with the actual settings of your machine.
NOTICE
Please observe chapter: Mass flow control with the M EMC function, page 90
.
To Next Page
Loading...