Rauch QUANTRON-A AXIS-M 20 Q - Drop Point; TELIMAT Quantity

Operation QUANTRON-A
45
4
4.6.4 Drop point
In this menu, you can enter the drop point for information purposes.
1. Open the Fertiliser settings > Drop point menu.
2. Determine the position for the drop point using the fertiliser chart.
3. Enter the determined value in the input field.
See chapter 4.13.2: Entering values with the cursor keys, page 84
.
4. Press the Enter key.
 The Fertiliser settings window with the new drop point is displayed.
4.6.5 TELIMAT quantity
In this menu, the TELIMAT quantity reduction can be set (in percent). This setting
is used for the activation of the boundary spreading function via the TELIMAT
sensor or the T key.
Entering the TELIMAT quantity:
1. Open the Fertiliser settings > TELIMAT Quantity menu.
2. Enter the value in the input field.
Refer to chapter 4.13.2: Entering values with the cursor keys, page 84
.
3. Press the Enter key.
 The fertiliser settings window with the new TELIMAT quantity is displayed.
NOTICE
Entering the drop point with the Q M-AXIS is merely informative and does not
affect the settings of the fertiliser spreader.
NOTICE
It is recommended to reduce the application rate at the boundary spreading side
by 20 %.