Operation QUANTRON-A
35
4
Entering the residual quantity when refilling:
1. Open the Weighing trip counter > Rest (kg, ha, m) menu.
The residual quantity from the last spreading process is displayed.
2. Fill the hopper.
3.
Enter the new total weight for the fertiliser in the hopper.
Also see chapter 4.13.2: Entering values with the cursor keys, page 84.
4. Press the Enter key.
The device calculates the values for the possible spread area and the
possible spread distance.
5. Press the kg key.
You are taken back to the operating screen.
Requesting the residual quantity during spreading:
During spreading, the residual quantity is continuously recalculated and dis-
played. See chapter 5: Spreading operation with the QUANTRON-A control unit,
page 87.
4.3.3 Zeroing the scales (AXIS with weigh cells only)
In this menu, the weight for the empty hopper is to be set to 0kg.
The following requirements have to be fulfilled for zeroing the scales:
the hopper is empty,
the machine is at a standstill,
the PTO shaft is switched off,
the machine is in a horizontal position and off the ground,
the tractor is at a standstill.
Zeroing the scales:
1. Open the Weighing/Trip counter > Zero scales menu.
2. Press the Enter key.
The weight for the empty scales is now set to 0kg.
The Weighing trip counter menu is displayed.
NOTICE
Zero the scales before each use in order to ensure that the residual quantity is
calculated correctly.
To Next Page
Loading...