Need help?Do you have a question about the Raycus RFL-C6600S and is the answer not in the manual?
General| Brand | Raycus |
|---|---|
| Model | RFL-C6600S |
| Category | Industrial Equipment |
| Language | English |
Explains warning symbols, laser classification, and associated hazards.
Details various safety labels and their specifications on the product.
Covers optical safety, electrical safety, and other general operating rules.
Highlights features, package contents, and unpacking procedures.
Details the basic operation conditions and warnings for the laser environment.
Lists important precautions and technical specifications for the laser.
Shows physical dimensions and details the laser output head interface.
Specifies cooling requirements, flow rate, temperature, and filter needs.
Outlines the step-by-step procedure for installing the laser product.
Describes the components and indicators on the front and rear panels.
Explains how to connect the power supply to the laser unit.
Defines pin assignments and functions of the CTRL-INTERFACE.
Details IP address setup and configuration steps for the Ethernet interface.
Provides steps for installing the output cable and safely starting the laser.
Introduces the features and interface of the laser control software.
Explains software language selection and laser authorization features.
Explains the different operating modes of the client software.
Details status, alarms, and parameters for main and slave control modules.
Presents status information for the ACDC modules.
Details the status information for the DCDC modules.
Explains AD mode, external enable, and modulation within REM mode.
Describes wiring and operation for internal control in ON mode.
Explains REM mode control for power and communication via wiring.
Details wiring and operation for analog control in REM mode.
Explains external control and clientware methods for the guide laser.
Describes how to enable and use the waveform editing mode.
Explains how to access and use the waveform editing interface.
Details checking saved waveforms and viewing their content.
Provides instructions for clearing and editing saved waveforms.
Details command codes, parameters, and instructions for waveform creation.
Illustrates control sequence diagrams for different operating modes.
Specifies modulation signal requirements and the laser shutdown procedure.
Explains alarm display on clientware and provides solutions for common alarms.
Details Raycus's general warranty policy and terms.
Specifies warranty exclusions and guidelines for product service and repair.
To Next Page
