0 No engraving or
cutting
Ò Skipped cut lines or skipped
engraving
¬ Set the right functions in the
parameter window (double
click on the plate)
0 Problems with
printing jobs to
the JobControl
Ò Printer settings ¬ Go to the TROTEC printer
properties (start/settings/fax
and printers).
¬ Choose the “Port” tab and select
the right directory and “local
port”.
¬ Choose the “Advanced” tab and
select “print directly to the
printer”
¬ Click OK
0 Problems with
cutting lines in
Corel Draw
Ò Color management ¬ Disable the color management in
Corel Draw.
¬ Please use the Corel help to find
the color management in your
Corel version
0 Printing fails
There was an
error found when
printing the
document
“xyz.cdr” to
TROTEC: Do you
want to retry or
cancel the job?
Ò Incorrect spool path ¬ Set valid spool path within
JobControl/Settings/Options/G
eneral/Spoolpath.
0 Jumbled bitmaps
when printing.
Ò “Print directly to the printer” not
activated.
¬ Go to the printer properties
(start/settings/fax and
printers).
¬ Choose the “Advanced” tab and
select “print directly to the
printer”
¬ Click OK
0 No colors are
displayed in
material dialog.
Ò Material file (e.g.
TR_CO2_Material.dat) is write
protected (copy from CD-ROM)
¬ Override write protection.
0 Error message
when attempting
to print. “Unable
to access printer
driver. Try
removing and
reinstalling this
printer driver.”
Ò Previous job-size too small.
Ò Reinstallation of the driver does not
resolve the problem!
¬ Go to the TROTEC printer
properties (start/settings/fax
and printers).
¬ Choose the “Print” tab and set
Width and Height to
something like 100mm (4 in)
¬ Click OK
¬
To Next Page
Loading...
