Service Manual Rayjet
FAQ’s
0 Job size orientation
does not match
the chosen
settings.
Ò CorelDraw message “Printer paper
orientation does not match one or
more document pages. Adjust
printer automatically?” was
accepted with “Yes”.
¬ Always prevent from automatic
adjusted page sizes by
selecting “No”.
0 A new JobControl
opens for each
job printed.
Ò File jc.ini is write protected. ¬ Remove write protection.
0 Unwished printer
driver default
settings
Ò Default settings are bad ¬ Go to Trotec printer properties
(Advanced / Printing defaults)
and change it
0 Unable to change
material settings
Ò You are logged in as an user ¬ Log in as administrator
0 Bad raster quality
Ò Default settings of raster options are
bad
Ò Raster correction in the JobControl
is not activated
¬ Go to printer properties (Print/
Halftone Settings ) and select
8x8
¬ JobControl / Settings / Options /
Process Options / Quality.
Check raster correction
0 Automatic cutting
line in not
modifiable in
JobControl
Ò You are not in the preview mode ¬ Make a double-click on the job
07/09/2010 Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support 49 / 53
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto: rayjet@troteclaser.com www.rayjetlaser.com
To Next Page
Loading...
