5.9 Compass Alignment
If it is necessary to change Compass Alignment
without carrying out the Automatic Deviation
Correction proceed as follows:-
• Push and hold Standby for 1 second to
select compass adjust mode.
• Push Display once to bypass Automatic
Deviation Correction
• Use the course change buttons to adjust the
heading displayed
• To exit compass adjust and store the new
setting push and hold Standby for 1 second
• To exit compass adjust without saving the
new setting push Standby momentarily
• To confirm the alignment procedure has been
correctly carried out, switch off power, switch
back on and check displayed heading.
Repeat the alignment procedure if incorrect.
42
To Next Page
Loading...
Need help?
General
