Raymarine SmartPilot X5 - Page 20

12 SmartPilot X-5 Tiller & GP Tiller Installation & Setup Guide
Use the following table to determine the required position for your vessel.
The Tiller drive mounting arrangement is shown in the following illustration. In the
following, dimension A represents the required distance between the tiller pin and the
center of the rudder stock, as determined from the above information.
Drive pin
distance from
rudder stock
Max degrees of
helm (with pilot
engaged)
Rate of helm
change
Force at rudder
457 mm (18”)
standard distance
31º 8 º per second 84 kgf
432 mm (17”) 33º 8 º per second 79 kgf
406 mm (16”) 35º 9 º per second 75 kgf
381 mm (15”) 37º 9 º per second 70 kgf
356 mm (14”) 39º 10 º per second 65 kgf
620mm (24.5")
620mm (24.5")
D10649-1
Dimension A Dimension A
90
o
90
o
620mm (24.5")620mm (24.5")