v
Contents
Preface
Safety notices
EMC Conformance
All Raymarine equipment and accessories are designed to the best industry
standards for use in the recreational marine environment. Their design and
manufacture conforms to the appropriate Electromagnetic Compatibility (EMC)
standards, but correct installation is required to ensure that performance is not
compromised.
Limitations on pressure washing
CAUTION: Do not pressure wash Raymarine products
Raymarine products must NOT be subjected to water pressures in
excess of CFR46 / IPX6 standards (for example, as generated by
commercial high pressure washing equipment). Products subjected
to water at these high pressures may experience water intrusion and
subsequent failure.
Raymarine products are waterproofed to CFR46 / IPX6 standards, which means that
when installed and operated in accordance with the appropriate product
documentation, they can be used in most weather and sea conditions. However, any
exposure to high-pressure water that exceeds the CFR46 / IPX6 standards, on or
around Raymarine products will invalidate the warranty for those products.
WARNING: Product installation & operation
This equipment must be installed, commissioned and operated
in accordance with the Raymarine instructions provided.
Failure to do so could result in personal injury, damage to your
boat and/or poor product performance.
WARNING: Switch off power supply
Make sure you have switched off the power supply before you
start installing this product.
WARNING: Navigational safety
Although we have designed this product to be accurate and
reliable, many factors can affect its performance. Therefore, it
should serve only as an aid to navigation and should never
replace commonsense and navigational judgement. Always
maintain a permanent watch so you can respond to situations
as they develop.
To Next Page
Loading...
Need help?
General
