58 SmartPilot X-5 Tiller & GP Tiller Installation & Setup Guide
To carry out a system reset:
1. Select the System reset (
RESET
) screen in Dealer calibration.
2. Press
+1
then press
AUTO
.
3. The screen will then show an
ARE YOU SURE
message:
•Press
auto
to cancel the reset
or
•Press
+1
again to select
YES
and reset the SPX-5 Tiller system.
4. You will then see the
CAL LOCK
screen:
• Hold down
standby
for 2 seconds to save the new default settings, then turn
the SPX-5 Tiller system computer power off and back on.
If you reset the system parameters, you must carry out the SPX-5 Tiller
system commissioning process before using the SPX-5 Tiller system again.
4.5 System defaults
Calibration Lock OFF Turn Rate Limit 7
Vessel Type SAIL BOAT Off Course Angle 20
Drive Type 3 AutoTack Angle Relative
Rudder Alignment 0 Gybe Inhibit ON
Rudder Limit 30 Wind Type APP
Rudder Gain 2 Wind Trim 5
Counter Rudder 2 Power Steer (Joystick) OFF
Rudder Damping 2 Cruise Speed 8
AutoTrim 1 Latitude 0
Response: 5 Autopilot Reset OFF
To Next Page
Loading...
