18 SmartPilot X-5 Tiller & GP Tiller Installation & Setup Guide
Tiller brackets
If the tiller is higher or lower than the mounting socket, use a tiller bracket to vary the
tiller pin height so the drive is horizontal.
If the drive is below the tiller, bracket size equals dimension D.
If the drive is above the tiller; bracket size equals dimension E - 25 mm (1”).
To use a tiller bracket:
1. Place the tiller bracket on the center line of the tiller (above or below) and establish
the correct position.
2. Mark the centers of the bracket mounting holes.
D8813_1
D
E
D8814_1
To Next Page
Loading...
